Filling Loop
 |
Locate filling loop. This is usually located near the boiler however there are alternative locations ie-: under the sink. If the customer can't locate the filling loop or is unable to re-pressurise. Contact installer |
| Ensure connected at both ends. If filling loop not connected at both ends - Contact installer | |
 |
Switch off boiler |
| Check to make sure all bleed valves are closed on radiators | |
 |
Slowly open lever / tap / screw on the filling loop. During filling water noise can be heard. |
 |
Close lever / tap / screw when pressure gauge dial reads 1 bar |